Electric Heating Mold Heating Furnace
- ruijia
- jiangsu
- 20 days
- 100 sets/month
We are a professional supplier of mold heating furnace, We can make a whole program for you, only need you to provide the following information:
1. Drawing
2. Product material requirements
3. Product Usage
4. output product introduction:
product description:
The electric heating mold furnace is an auxiliary equipment used in conjunction with the extruder. Its main function is to heat the mold to a temperature close to the aluminum rod to facilitate extrusion molding. The advantage of the furnace is that it is convenient, quick and energy-saving to take and put the mold.
The outside of the furnace shell is welded by ordinary steel plate and section steel. The furnace is welded by the heat-resistant steel plate of the through hole. The middle part is made of light brick and aluminum silicate fiber blanket. As the heat insulation material, the outer surface is made of slag cotton as the second. Secondary insulation; the innermost layer is a special cabinet brick supporting the electric heating body, which is an ordinary high aluminum brick, and the electric heating wire is supported thereon.
After the heating element is heated, in addition to directly transferring heat to the inner hole of the through hole, the hot air circulating fan is used to transfer the heat generated by the heating element into the furnace through the air, and the mold is heated to heat the mold quickly and uniformly. There are two thermocouples in each heating zone for temperature measurement, temperature control and over temperature alarm system.
The mold furnace fan is assembled by high-temperature stainless steel fan blades and high-temperature stainless steel shafts and high-temperature bearings. It is adjusted by static and dynamic balance to achieve better low-sounding and stable operation, and air-cooled and water-cooled around its high-temperature bearings. The device can better control the temperature in the furnace and dissipate with the fan shaft.
The structure of the material is welded by ordinary steel plate and section steel, and the track of the material is welded on the upper part. The material is equipped with a walking wheel, which can enter and exit with the track. The material car is welded with 20mm thick A3 plate and has reasonable air outlet holes, which can make the mold have better soaking effect.
Electric heating mold heating furnace：
Drawer mold heating furnace：
Well type mold heating furnace：
